| Dimensions: |
10.8 cm x 7 cm x 4.6 cm (4.25 in. x 2.75 in. x 1.8 in.) |
| Material: |
High impact ABS plastic enclosure |
| Operating Temperature: |
-40°C to +49°C (-40°F to +120°F) For UL Certificated installations, 0°C to +49°C (+32°F to +120°F) |
| Radio Frequency Interference (RFI) Immunity: |
No alarm or setup on critical frequencies in the range from 26 MHz to 950 MHz at 50 V/m. |
| Height (recommended): |
2 m to 3 m (6 ft to 10 ft) |
| Location: |
Wall or corner |
| Internal and Pattern Pointability: |
Coverage is adjustable -18° to +2° vertically. |
| Alarm: |
DS935Z: Form reed relay rated at 3.0 W, 125 mA at 28 VDC for resistive loads and protected by a 4.7 Ω resistor in the common C leg. |
| ZX935Z: Signal through POPIT data bus. |
|
| Tamper: |
DS935Z: Normally-closed (with cover in place) tamper switch. Maximum current load is 25 mA. |
| ZX935Z: Signal through POPIT data bus. Signaled as Missing. |
|
| Trouble: |
DS935Z: Solid state output shorts to auxiliary power negative when activated. Tamper contacts rated at 28 VDC, 125 mA maximum. |
| ZX935Z: Signal through POPIT data bus. |
|
| Current Draw: |
DS935Z: 20 mA at 12 VDC |
| ZX935Z: <0.5 mA nominal, 2 mA in alarm with LEDs enabled. Do not leave Walk Test LEDs enabled. |
|
| Voltage (Input): |
DS935Z: 9 VDC to 15 VDC |
| ZX935Z: Power comes from two-wire Zonex Bus. |
|
